Flared fittings pre-installed

Pre-installed , you should try to keep the tube and the coaxial connector body , if the pipe deflection is too large will cause seal failure.
    Preloaded force should not be too large. Should make the inner edge ferrule tube wall just embedding , card sets there should be no significant deformation . During pipeline connection, then the provisions of the tightening force assembled . φ6-10mm ferrule tightening force of 64-115N, φ16mmr 259N, φ18mm for 450N. If the pre- deformed when the card holder will lose the seal.
2 , prohibits adding sealant filler. It was sealed in order to achieve better results, apply sealant put on the card , the results sealant being washed into the hydraulic system , causing the hydraulic components orifice blockage failures. 3, the connecting pipe should be sufficient deformation of the tube margin , to prevent the tube subjected to tensile stresses. 4, the connecting pipe should be avoided when it suffered lateral force , lateral force caused Mifengbuyan over the General Assembly . 5, the connecting pipe should be a good one tight , to avoid multiple disassemble , otherwise it will seal performance deteriorated. Hydraulic pipe fittings structural features hydraulic fittings points A and B two structural forms , A-type maximum pressure rating of PN32 suitable for the occasion . A hydraulic hose assemblys from the joint body , sleeves and jacket nut composition, coat the outer cone nut clamping pipe and forcing cone piping cone close to the connector body and acts as a seal . Protective casing on the pipe and the guide. B-type fitting nut from the fitting body and the jacket structure, clamping nut jacket pipe outside the cone , the forcing cone piping cone close fitting body and acts as a seal . Flared fittings have a solid connection , high pressure, tightness and good repeatability, installation , maintenance, etc. .